News Baldur’s Gate 3 tip: All Adamantium Forge mold locations
Published on 08/15/2023 at 18:15
Share :
The adamantium forge is a way to have very good weapons and armor from the first act of Baldur’s Gate 3, but you still need to have the different molds that allow it. In this article, we list each of the locations where you can find them.
Adamantium Longsword
This mold is the very first one you will come across in Baldur’s Gate 3, although it is quite easy to miss it. Indeed, the latter is at the level of the iron bridge next to which the levers are located when you go to head for the adamantium forge for the first time.
Cimeterre en adamantium
The next mould, that of the scimitar, is not far away. Indeed, if that of the long sword is on the iron bridge, this time it is necessary to go on the stone bridge using the platform controllable by levers. Then move forward until you fall again on levers. There, a skeleton is next to it, search it and you will find the mold.
Clibanion en adamantium
Once this mold has been recovered, you will be able to have another one in stride! Indeed, you will be able to jump on a platform which is to the left of where you are. It is on the latter that you will find the Clibanion mold in adamantium.
A mass of diamonds
Once you unlock the forge teleport point, just look on the tables that are nearby. This is where you can get your hands on a new mould, the one allowing you to craft the adamantium mace.
Adamantium Scale Armor
While you’re there, keep heading south after you find this mold. You will find a little further that of the scale armor. Attention, it’s the only mold you’re going to have to fight for, enemies attacking you when you arrive.
Adamantium Shield
For the adamantium shield mold, you will have to return to the stone bridge where you found the scimitar one. Except that this time, no need to go all the way. Indeed, you will come across a large iron door right from the start. Crochet it and you will find the mold on the skeleton at the very end of the staircase.
Now that we have the molds, here’s how to weaponize them. The first step is going to be to put the desired mold in the mold compartment. Then insert Mithral into the crucible. Once it’s done, turn the lava valve being careful that your characters are out of danger.
Finally, pull the lever to bring down the giant hammer. Be careful, again if your characters are below, they will take a lot of damage. Finally, know that the first time you use the forge, a boss fight will start
so be ready!
Summary of our Baldur’s Gate 3 guides
About Baldur’s Gate III
Test
Baldur’s Gate 3: new GOTY 2023 contender and best RPG of its time!
News astuce
Tier List Baldur’s Gate 3: The best classes and compositions to face all the dangers of the game!
News astuce
Baldur’s Gate 3: These ingenious cheats just might change the way you play!
News astuce
The Adamantium Forge Baldur’s Gate 3: how to get there and how to defeat Grym the Guardian?
